INSTRUCTIONS:
Read Carefully Please discuss
application with your dental professional. The following is
a general use guideline.
PREPARE THE DENTAL TRAY FOR YOUR MOUTH
Place the empty dental tray in your mouth and bite down very
gently. If the dental tray is comfortable -- and your upper
and lower front teeth are COVERED by the dental tray -- you
are ready to use Oraparx® Professional. If you are having difficulties
try the following suggestions:
If too big, cut ¼ inch off each end with scissors until
it fits your mouth.
If too small, it's not a problem; the dental tray enlarges
with use (see suggestion below).
Teeth not covered by dental tray. Apply Oraparx® Professional
with a clean finger to areas not covered by the dental tray.
Oraparx® Professional is an adhesive dentifrice.
BEGIN USE
Unscrew the tube cap and remove the safety seal. Replace
the tube cap.
Squeeze Oraparx® Professional firmly into the groove on
one side of the dental tray. Do not overfill.
Turn the dental tray over and repeat so that both sides
of the dental tray contain Oraparx® Professional.
Place the dental tray in your mouth making sure your bottom
and top teeth fit into the grooves of the dental tray. Apply
Oraparx® Professional with a clean finger to areas not covered
by the dental tray.
Bite down gently. DO NOT bite through the dental tray.
Leave the dental tray in your mouth for 5 to 10 minutes
but no longer than 20 minutes.
Use once every other day, one time per day or two times
per day depending on your oral condition. More frequent
use creates an overlapping additive effect.
AFTER AN ORAPARX®
PROFESSIONAL TREATMENT
Remove the dental tray and place in bowl to rinse.
Spit out paste. Brush teeth to remove residual paste with
water only.
Rinse your mouth and the dental tray thoroughly. Use your
CLAMSHELL to hold the dental tray as it dries.
Set the dental tray aside to air dry or carefully squeeze-dry
in a towel. CLAMSHELL does not close.
Your dental
tray has absorbed saliva and will have expanded in size.
It will return to its original size as it air dries. Allow
your dental tray to completely dry before your next treatment.
TIPS AND SUGGESTIONS
Alternate
the tray if it is not covering your posterior molars i.e.
place to the left on first use, place to the right on second
use, thus alternating placement with each use.
If
the tray will not cover areas of your teeth, place the paste
in those areas with a clean finger (product is adhesive
and will work as long as the tray is in place.
If
you can not use the tray for a full 10 minutes, simply use
it for as long as it is comfortable.
Use
Oraparx® Professional in the shower! Keeping it handy is
an easy way to incorporate Oraparx® Professional into your
normal routine and enhance your oral hygiene.